Vacuum Operating Instructions - Landa ECOS 7000 Series Operator's Manual

Vacuum Operating Instructions

STEP 1: Keep the working area free of rubbish. Attach the vacuum hose to the 1-1/2" hose barb located in the rear
of the trailer. Attach the vacuum head to the other end of the vacuum hose. Locate the vacuum head at the lowest
area of standing water. If washing, set up a damming or a containment system. Start engine as outlined in
"Pressure Washing Instructions".
STEP 2: To reclaim water, press the Vacuum Motor
switch located in the control cabinet to the "ON"
position. The vacuum system will draw water into the
40 gallon holding tank and will automatically stop when
the tank is full.
24 Landa ECOS 7000 Operator's Manual 9.801-316.0 - G
STEP 3: Located in the vacuum tank is the large debris
sock filter. To clean the sock filter turn off vacuum motor
and then remove the vacuum hose and the two rubber
clamps located on the top of vacuum inlet. Grasp the
two handles and lift the lid vertically until the sock filter
clears the opening. Remove the filter and dispose of
the contents per local regulations. Replace and secure
the bag filter, lid and vacuum hose.