Pressure Washer Instructions - Landa ECOS 7000 Series Operator's Manual

Pressure Washer Instructions

STEP 1: Read safety, installation
and preventative maintenance
instructions before starting
machine. Fill the water tanks from a
clean water source. If filling from a
hydrant, flush out any rust before
connecting water supply. The water
supply may remain connected for
further filling. Tanks can also be
filled by removing lid and feeding
water directly into tanks.
CAUTION: To prevent damage to
the pump, incoming water
temperature must not exceed
140° F.
STEP 4: With the spray nozzle
pointed away from you or anybody
else, press the trigger on the spray
gun to obtain pressurized cold
water spray.
STEP 2: To fill the two outer tanks,
turn the inner tank valve to the
"OFF" position and the outer tank
valve to the "ON" position. To fill all
four tanks turn the two bottom
valves to the "ON" position. The
two outer tanks are linked together
with a 1" line to distribute the
weight of the water. The two inner
tanks are also linked together
STEP 5: Pull wand coupler collar
back and insert desired pressure
nozzle into wand coupler. Then
secure by pushing coupler collar
forward.
CAUTION: Never replace nozzles
without engaging the safety
latch on the spray gun trigger.
Landa ECOS 7000 Operator's Manual 9.801-316.0 - G
STEP 3: Read engine manual
provided and pull choke. Pull spray
gun trigger to relieve pressure.
Turn the engine switch to the
START position and hold until the
engine starts.
NOTE: Do not engage the
electric starter for more than five
seconds at a time. If the engine
fails to start, release the switch,
pull spray gun trigger and wait ten
seconds before operating the
starter again. Once the engine
starts, push the choke in.
STEP 6: For hot water, turn the
burner switch to ON and set the
thermostat knob to the desired
temperature. When a steady
stream of water flows out of the
spray gun the burner will light auto-
matically.
NOTE: Do not start machine with
burner switch on. The green light
will be illuminated when the
burner switch is in the on
position.
21