Assembly Instructions; Battery Installation - Landa ECOS 7000 Series Operator's Manual

Assembly Instructions

STEP 1: Install water hose (5/8"
minimum) to lower hose reel.
Connect lose end of water hose to
water supply. Minimum flow should
be 5 gpm.
STEP 4: Check engine and pump
oil level by removing oil dipstick,
making sure oil is on proper
indicator marking on pump. Oil
should be visible one half way up
sight glass.

Battery Installation

Due to Federal Regulations
concerning shipment of corrosive
chemicals, batteries are not
shipped with this machine.
Local purchase of battery will be
the responsibility of the owner.
Automotive type 12 Volt Group 24
20
STEP 2: Install high-pressure hose
to upper high-pressure hose reel.
STEP 5: Fuel tanks are located on
the driver side cabinet. Fill red tank
with gasoline. Fill the black tank
with fuel oil (diesel). DO NOT
confuse gasoline and oil tanks.
Keep proper fuel in proper tank.
battery is recommended for
placement within the weather
resistant box. Follow safety and
installation instructions furnished
with the battery.
Red Cable is attached to battery (+)
positive terminal, black cable is
connected to battery (-) negative
terminal.
Important: Remove the battery
when trailer in not in use to
prevent the battery from
draining.
Landa ECOS 7000 Operator's Manual 9.801-316.0 - G
STEP 3: Attach variable wand to
spray gun, use teflon tape on
threads to prevent leakage. Attach
male coupler to the inlet on gun
using teflon tape on threads. Attach
spray gun assembly to quick
disconnect of high pressure hose.
To prevent injury or damage when
transporting trailer, attach the loose
ends of both hoses to the fittings
located on the base of the upper
reel. Wind reels to remove any
excess hose and lock reels in
place.
Install proper battery making
sure that the red cable is
attached to the positive terminal
Use a 12v Group 24 battery.