Page 1
Operating instructions Airfilter MINI TEKA Absaug- und Entsorgungs- technologie GmbH Industriestraße 13 D-46342 Velen Postfach 1137 D-46334 Velen Tel.: +49 (0) 2863 9282-0 Fax: +49 (0) 2863 9282-72 E-Mail: sales@teka.eu www.teka.eu...
Page 2
Please enter here the specific data relating to the Airfilter you have purchased, so that if you contact TEKA GmbH by tele- phone you will have the necessary data immediately on hand: Description and type of the ap- Airfilter pliance: Year of construction: Machine no.:...
7.2 Replacement of the combifilter ..................15 Fault and error search ..................20 Disposal ......................22 10 Spare parts and parts subject to wear and tear ..........23 11 Declaration of conformity TEKA-Airfilter ............24 Instruction record for Airfilter MINI ................ 25...
1 Introduction In recent years, a special type of welding fume extraction systems has become an ever more prominent factor: Filtering of welding fumes and return of the filtered air into the workshop area. This shows that the issue of environmental consideration has turned for the better for all concerned.
2 Intended use 2.1 Intended use The Airfilters MINI are exclusively for the purpose of suction of gases and fumes, which are contaminated with harmful substances and which occur in the following areas of activity: – Soldering in the electronics industry, –...
Do not use the filter unit when any one or more components of the system are defective, • missing or damaged. In any one of these instances contact the TEKA Service De- partment: Phone: ++49 (0) 2863 / 92 82 0 When extracting carcinogenic welding fumes as from the processing of nickel or chrome al- •...
5 Transport and Setting up During transport and interim storage, the device has to be protected against weather condi- • tions. During transport, the device must be prevented from falling over and shifting. • Lift and transport the device with the help of a manual lift truck or a forklift. •...
The suction arm may be assembled in different ways depending on the design. 1 Suction arm, nominal diameter 75 mm 2 Adapter plate NW75/50 3 Suction arm, nominal diameter 50 mm 4 Suction hose Figure 2: Assembly of various suction arm types on the Airfilter MINI BA_Airfilter Mini_151210_GB.doc - 11 - 22.07.2013...
6.1.2 Connection of an external control The Airfilter is switched on or controlled (remote switch automatic mechanism) either on the membrane keyboard or by an external control (e.g. of the machine to be extracted). The remote switch automatic mechanism is connected to the Airfilter using a nine-pole cable with sub-D9 plugs.
6.1.3 Connection of the Airfilter 1 Mains cable 2 Appliance inlet / On/off 3 Connection cable for remote control (not included) 4 Sub-D9-connection 5 Suction arm (not included) 6 Suction hose (not included) Figure 3: Connection of the Airfilter Connect the Airfilter as follows: ●...
For the instructions we recommended the use of the added instruction record on the last page of this manual. Changes to settings on the Airfilter may only be carried out by specially trained service per- sonnel of TEKA GmbH. 6.3 Operation Attention: Possibilities of adjustment of the programme, menu navigation ecc of the system you will find in the separate attached manual of steering.
7 Maintenance 7.1 General information All service work must be carried out within the given deadlines and with the corresponding care. The life and production quality of the Airfilter can be maintained through precautionary service of the components. Besides the regular cleaning you are urgently advised to replace parts subject to wear and tear as a precautionary measure.
Page 16
Switch off Airfilter ● Switch off the Airfilter via the membrane keyboard using the button Alternatively you can switch off the machine to be extracted. This way the Airfilter will be switched off automatically after the set post running time. ●...
Page 17
Remove combifilter 4 Handle 5 Combifilter Figure 5: Remove combifilter ● Hold the handle (4) of the combifilter (5) with one hand and pull the combifilter out of the filter housing. Use the other hand to support the combifilter. ● Place the whole combifilter with the pre-filter mat on top of it into a plastic bag, which can be seal tightly, and seal it.
Page 18
Insert new combifilter In principle, the new combifilter will be inserted in the reverse order. Please observe the fol- lowing work steps: Figure 6: Insert new combifilter ● Remove the combifilter, which is to be inserted, with the already integrated pre-filter mat from the packaging.
Page 19
Close the housing of the Airfilter 6 Service flap 7 Latch Figure 7: Close filter housing ● Hold the service flap (6) in both hands and press it evenly onto the service opening, until the latch (7) engages in the service flap. BA_Airfilter Mini_151210_GB.doc - 19 - 22.07.2013...
Air intake channel too narrow. Check air intake channel, if necessary correct error found. Error on the Airfilter. Contact TEKA GmbH, if nec- essary return Airfilter. Airfilter is not running. Plug connection power supply not Check/correctly plug in plug or wrongly plugged in.
Page 21
Fault Cause Correction No control signal for remote control Correction according to the of machine. operating instructions of the machine. Error on the Airfilter. Contact TEKA GmbH, if nec- essary return Airfilter. BA_Airfilter Mini_151210_GB.doc - 21 - 22.07.2013...
9 Disposal To facilitate the impeccable performance of your TEKA dustoo extraction device along with the dis- posal of the extracted dust, we are pleased to offer you the following services: Help in finding a residue disposal company situated near you.
10 Spare parts and parts subject to wear and tear Designation Art. no Combifilter element, size: 305x305x200 (Airfilter Mini) 10031941 Pre-filter mat set of 10 (Airfilter Mini) 10033 Caster wheel D=50mm, with brake 2263054 Caster wheel D=500mm, without brake 2263055 Suction turbine 1.2 kW, DC, 230V...
Declaration of conformity TEKA-Airfilter TEKA Absaug - und Entsorgungstechnologie GmbH Industriestraße 13 D - 46342 Velen Phone.:+49 2863 92820 Fax:+49 2863 928272 e-Mail: sales@teka.eu Internet:http://www.teka.eu We herewith declare in sole responsibility that the before mentioned product, starting from machine No.:...
Instruction record for Airfilter MINI By his signature, the staff member confirms that he has been instructed regarding the following items: Instruction item completed Description of the filter unit Operation and application of the filter unit Explanation of the safety instructions...
Need help?
Do you have a question about the Airfilter MINI and is the answer not in the manual?
Questions and answers