Converting Files From Tape To Disk; Procedure - Agilent Technologies 85103F Installation Manual

Converting Files from Tape to Disk

Each performance upgrade package includes a tape to disk conversion program. Use this
program to convert DATA, MEMORY, MEMORY ALL, and DELAY TABLE files from tape
to disk. This conversion will make these files available to the 8510C.
The utility program creates CITIfile versions of the tape files on a standard double-sided
(720 kByte) or a high-density (1.4 MByte) 3.5-inch diskette. For best performance, we
recommend that you use a 9122C drive and high-density diskettes.
You cannot convert instrument and hardware state files, or calibration
NOTE
kit files under this procedure. Refer to
end of this procedure. The 8510C cannot use the learn strings of earlier
analyzer versions.

Procedure

1. Connect the equipment as shown in
2. Turn the equipment on.
3. On the 8510, press
Figure 2 Equipment Setup for Data Transfer
4. Insert the Software Tool Kit disk included in the upgrade kit into drive 0 of the 9122
disk drive.
85103F Performance Upgrade Installation Manual
Figure
INSTRUMENT STATE RECALL
The 85103F Upgrade Package (8510A/B to 8510C)
Converting Files from Tape to Disk
"Converting Cal Kit Files"
2.
and select
[MORE], [FACTORY PRESET]
at the
.
9