Ventilation Speeds And Modes; Co Setpoint - Eurofred daitsu RHR-SCO2 User Manual

DAITSU WIRELESS CO

3.2.1 VENTILATION SPEEDS AND MODES.

The ventilation system operates in one of the following modes. In each of these modes, the control device adjusts the
ventilation system to a configured ventilation level.
The control device drives the fan according to the highest values sent by the linked wireless sensors. When you start the timer
mode from this device, the ventilation will be active for 30 minutes.
3.2.2 CO SETPOINT
2
The device measures the level of CO
The device controls the ventilation accordingly to keep the measured level of CO
Comfort mode, the requested level is the same as the configured value. In Eco mode, the requested level is 250 ppm above
the configured value.
NOTE
The device stores the fan speed values configured on the control device and requests them from there. The device
stores the CO
I 6
PROBE / INSTALLATION AND OPERATION MANUAL
2
ABSENCE MODE:
It represents periods of non-occupancy, when the heat recovery unit will operate at the lowest capacity.
AT HOME MODE:
It represents occupancy of the home or a room. By selecting this button, the heat recovery system
knows that there is one person (or more) in the room or home. It will set the speed to the default level.
MAXIMUM TIMER:
High fan speed, for a limited time. When the button is pressed, the heat recovery unit will reach maxi-
mum speed for 30 minutes.
ECO MODE:
Sensor-based automatic ventilation. In ECO, the system will begin at a higher CO
in COMFORT mode.
COMFORT MODE:
Sensor-based automatic ventilation. The system will accelerate the CO
default activation value is exceeded.
in the air continuously and compares the measured value to a configured setpoint.
2
setpoint itself and does not communicate it to any other device.
2
level to ventilate like
2
-based ventilation after a certain
2
below the requested level. When it is in
2