Table of Contents
Advertisement
Product introduction
Warning
Improper use, misuse or misapplication can lead to
personal injury and damage to the equipment!
1
PN:
2
Type:
3
Serial No:
4
U:
5
I :
1/1
6
P1:
p:
bar
7
Tmin amb:
°C
8
Tmin liquid:
°C
9
Net weight:
kg
10
DK-8850 Bjerringbro, Denmark
Fig. 1
Nameplate
Pos.
Description
1
Product number
2
Type designation
3
Serial number
4
Voltage
5
Nominal current
6
Nominal power
7
Nominal pressure
8
Min. ambient temperature
9
Min. liquid temperature
10
Weight of the system without water
11
Revision: A, B, C
12
Frequency
Production site (e.g. "P1" for India) followed by a four-
13
digit code for year and week of production (e.g. "1523"
for year 2015 and week 23)
14
Type of ground connection
Fuse rating that should be installed as protection of the
15
system on the power grid
16
Max. short-circuit current
17
Max pressure
18
Max. ambient temperature
19
Max. liquid temperature
20
Country of origin
21
Marks of approval
Type key
Example: AQP-CE-UF-...
Code
Type
AQP
Certification
CE
Technology
UF
11
Model:
12
13
PC:
14
V f:
Hz
15
A Max Fuse:
AC
W
I K Max eff:
kA
16
pmax:
bar
17
Tmax amb:
°C
18
Tmax liquid:
°C
19
Assembled in India
20
21
Description
AQpure
With CE mark
Ultrafiltration
Manual control is protected with a special password
and must only be used by Grundfos service
Caution
specialists.
Warning
Danger of personal injury due to contact with
chemicals!
External CIP must only be carried out by certified
service staff. For further information about external
CIP see the Service Instructions.
The operating company is responsible for the
preparation of the installation location according to
sections
Obligations of the operating company
and Installation.
Caution
The installation itself (installation of membrane and
GAC filter, hydraulic and electrical connection etc.)
must only be done by certified service staff according
to the separate service instructions, which are
supplied to certified service staff only.
Operation
The main breaker should be switched to the OFF
Caution
position in case of emergency and before performing
electrical maintenance of the system.
Only certified service staff is allowed to enter the
Caution
service menu.
The maintenance instructions of the HMI are
shortened.
Caution
Maintenance must only be performed in accordance
with the complete instructions given in this
document!
Maintenance
Warning
Cleaning and maintenance must only be carried out
by authorised and qualified staff.
Wear the stipulated personal protective equipment
(protective clothing, gloves, goggles, etc.)!
Observe the chemical manufacturer's safety data
sheets (MSDS) and safety instructions of the used
chemicals!
Safety installations, which have been disabled during
maintenance, must be enabled again immediately
after maintenance.
Warning
Danger of electric shock!
Water or any other liquids on electrical components
can lead to personal injury from electric shock.
Furthermore, damage to the equipment can be
caused due to short circuits.
Keep all electrical components dry!
Cover electrical components during maintenance
with a water-tight foil!
Before reassembling make sure, that all parts are
Caution
clean, dry and undamaged!
Warning
Death or serious injury
Danger of malfunction or damage to the product.
The AQpure system must be earthed with an earth
cable.
Equipotential bonding is installed between all
interfaces and metallic parts to prevent build-up of
static electricity.
All equipotential bonding and earthing must be
reinstalled properly after repair or maintenance.
3
Advertisement
Table of Contents
