Filling The System With Manual Filling Link - Bosch Thermotechnik FILLING LINK Installation And Operating Manual

Filling the system with manual filling link

5 Filling the system with manual filling link
▶ If the needle on the appliance pressure gauge reads less than 1 bar or low
pressure shown on HMI, re-charge the system.
▶ Pull the blue lever down to start the filling process.
▶ Monitor the pressure gauge or HMI.
▶ When the needle reaches between 1 to 1.5 bar on the gauge or HMI indicates that
the pressure is ok, release the blue lever to stop the filling process.
Fault - 333
Boiler temporarily
shut down due to
water pressure too low
Pressure: 0.2 bar
Fig. 6 Filling the system (manual filling link)
10
1.
3.
Fault - 1017
Water pressure
too low
Pressure: 0.6 bar
1.5 bar
4.
1 bar
Min
2.
Max
Water pres. Ok
Finish topping up
Pressure OK: 1.6 bar
0010019844-001
6720884379 (2018/03)