hestan KRP Series Installation Manual page 31

Refrigerators, freezers and wine storage

Hide thumbs Also See for KRP Series:

Available languages

FINAL INSTALLATION

INSTALLING TWO OR MORE UNITS TOGETHER (cont.)

INSTALLING TWO OR MORE UNITS TOGETHER

Position the two units so that, when joined, they can be rolled into their final position.

1) For KRP units, place the anti-condensation

insulator according to its directions.

2) Place the units side by side, and check leveling.

The two units must be at the same height before

connecting. (Item 3, this page)

The side connectors should just touch along their

length.

3) At the rear, mount the joining brackets to one

unit, then the other. (Item 2, this page)

4) The top may also require a connector. Install if

required/provided. (Item 4, this page)

5) At the front, attach the aluminum center

connectors together using the fasteners provided.

(Items D, previous page)

6) Snap the center trim cover into place.

(Item 5, this page)

MOVING TWO UNITS INTO FINAL POSITION

Make sure the side connectors will fit the cutout

width. See "CHECK/ADJUST SIDE TRIM" on page 30.

The procedure is the same as for a single unit. See

following page.

(CONT.)

(cont.)

Table of Contents