hestan KRP Series Installation Manual page 18

Refrigerators, freezers and wine storage

Hide thumbs Also See for KRP Series:

Available languages

OVERLAY PANELS

DOOR AND DRAWER OVERLAY PANEL PREPARATION (continued)

DOOR AND DRAWER OVERLAY PANEL PREPARATION

Mounting the Brackets

4) Position the brackets on each set of marks to make sure

they are aligned. (4)

Note that the support bracket mounts with its flange

toward the top of the door.

•

If necessary, drill starter holes in the panel. (5)

(Use a drill stop to avoid drilling through or damaging

the finish surface.)

The installation kit includes 5/8" screws. If the panel isn't

substantially thicker than 5/8", you'll need shorter screws.

1) Screw the brackets in place. (6)

Drawer Panel

When preparing the Drawer Panel, follow the same

instructions as per the door panel, but make sure

measurements are taken starting from the top edge. (7)

The support bracket faces the opposite way from the door

panel bracket. (Compare images 4 and 8.)

(CONT.)

(continued)

Table of Contents