LG WT22WS6HP Owner's Manual page 85

global_main.book.book Page 37 Thursday, August 13, 2020 4:39 PM
Operation
Symptoms
Appliance will not
operate.
Detergent is not
dispensed completely
or not dispensed at all.
Possible Cause & Solution
Control panel has powered off due to inactivity.
• This is normal. Press the POWER (ENCENDIDO/APAGADO) button to turn
on the appliance.
Appliance is unplugged.
• Make sure that the cord is plugged securely into a working outlet.
Water supply is turned off.
• Turn on the water supply tap completely.
Controls are not set properly.
• Make sure the cycle is correctly set. Close the door and press the START/
PAUSE (INICIO/PAUSA) button.
Circuit breaker/fuse is tripped/blown.
• Check house circuit breakers/fuses. Replace fuses or reset breaker. The
appliance should be on a dedicated branch circuit. The appliance will
resume the cycle where it stopped once power is restored.
Control needs to be reset.
• Press the POWER (ENCENDIDO/APAGADO) button, then reselect the
desired programme and press the START/PAUSE (INICIO/PAUSA) button.
START/PAUSE (INICIO/PAUSA) was not pressed after a cycle was set.
• Press the POWER (ENCENDIDO/APAGADO) button, then reselect the
desired cycle and press the START/PAUSE (INICIO/PAUSA) button. If the
START/PAUSE (INICIO/PAUSA) button is not pressed within a certain
time, the appliance will be turned off.
Extremely low water pressure.
• Check another tap in the house to make sure that household water
pressure is adequate.
Appliance is too cold.
• If the appliance has been exposed to temperatures below freezing for an
extended period of time, allow it to warm up before pressing the POWER
(ENCENDIDO/APAGADO) button.
Appliance is heating the water or making steam. (some models only)
• The drum in the appliance may stop operating temporarily during certain
cycles, while water is safely heated to a set temperature.
Too much detergent is used.
• Follow the guidelines provided by the detergent manufacturer.
TROUBLESHOOTING 37 EN