Table of Contents
Advertisement
Setting the User 1/User 2 mode
There are two user-definable modes if the current available picture modes are not suitable
for your need. You can use one of the picture modes (except the User 1/User 2) as a starting
point and customize the settings.
1.
Press MENU/EXIT to open the On-Screen Display (OSD) menu.
2.
Go to the PICTURE > Picture Mode menu.
3.
Press
/
4.
Press
to highlight Reference Mode.
This function is only available when User 1 or User 2 mode is selected up in the Picture Mode
sub-menu item.
5.
Press
/
6.
Press
to select a sub-menu item to be changed and adjust the value with
See
"Fine-tuning the image quality in user modes"
7.
When all settings have been done, highlight Save Settings and press MODE/ENTER
to store the settings.
8.
The confirmation message 'Setting Saved' displays.
Fine-tuning the image quality in user modes
According to the detected signal type, there are some user-definable functions available
when User 1 or User 2 mode is selected. You can make adjustments to these functions
based on your needs.
Adjusting Brightness
Highlight Brightness in the PICTURE menu and adjust the values by pressing
the projector or remote control.
The higher the value, the brighter the image. And lower
the setting, darker the image. Adjust this control so the
black areas of the image appear just as black and that
detail in the dark areas is visible.
Adjusting Contrast
Highlight Contrast in the PICTURE menu and adjust the values by pressing
projector or remote control.
The higher the value, the greater the contrast. Use this
to set the peak white level after you have previously
adjusted the Brightness setting to suit your selected
input and viewing environment.
to select User 1 to User 2.
to select a picture mode that is closest to your need.
below for details.
+50
+30
0
+30
Operation
/
.
/
on
+70
/
on the
-30
35
Advertisement
Table of Contents
