Table of Contents
Advertisement
Connecting Component Video source devices
Examine your Video source device to determine if it has a set of unused Component Video
output sockets available:
•
If so, you can continue with this procedure.
•
If not, you will need to reassess which method you can use to connect to the device.
To connect the projector to a Component Video source device:
1.
Take a Component Video cable and connect the end with 3 RCA type connectors to
the Component Video output sockets of the Video source device. Match the color of
the plugs to the color of the sockets; green to green, blue to blue, and red to red.
2.
Connect the other end of the Component Video cable to the COMPONENT socket
on the projector. Match the colors of the plugs to the colors of the jacks-green to
green, blue to blue, and red to red.
To connect the projector to an Audio source device:
1.
Take a suitable audio cable and connect one end to the AUDIO OUT jack of the AV
device. Connect the other end of the cable to the AUDIO IN jack on the projector.
Once connected, the audio can be controlled by the projector On-Screen Display
(OSD) menus. See
The final connection path should be like that shown in the following diagram:
Audio cable
•
If the selected video image is not displayed after the projector is turned on and the correct
video source has been selected, check that the Video source device is turned on and
operating correctly. Also check that the signal cables have been connected correctly.
•
If you have already made an HDMI Video connection between the projector and this
Component Video source device using HDMI Video connections, you need not connect to
this device using a Component Video connection as this makes an unnecessary second
connection of poorer picture quality. See
for details.
"Audio Settings" on page 45
AV device
for details.
Component Video cable
"Connecting Video source devices" on page 19
Connection
21
Advertisement
Table of Contents
