Remote Control - LG UltraFine 65EP5G Owner's Manual

20
• (RJ45, 8pin): The input signal of the GPI controller can be used as an output.
• : Updates the software.
• : Connects HDMI signal. Please refer to the HDMI supported resolutions page. (Refer to page 68)
• (SDI Input): Connects SDI signal. Please refer to the SDI supported resolution page. (Refer to page 64)
• (SDI Output): Outputs the signal entered through the SDI input terminal. (Loops through the SDI input
signal.)
• : The REF IN is used for analog reference signals black burst and tri-level sync for locking.
• : This is a slot that supports SDI optical signals up to 25Gbps and SDI over IP.

REMOTE CONTROL

The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully to
use the monitor correctly. To install batteries, open the battery cover, place batteries (1.5 V AAA) matching
terminals to the labels inside the compartment, and close the battery cover. To remove the batteries, perform the
installation actions in reverse. The illustrations may differ from the actual accessories.
CAUTION
• Do not mix old and new batteries, as this may damage the remote control.
• Be sure to point the remote control toward the remote control sensor on the monitor.
• Some features of the remote control may not be supported in certain models.
• The product's internal and external batteries should not be exposed to excessive heat such as direct sunlight, fire, or
the like.
and