Cambridge Audio AXR100D Manual page 4

OVERLOADING
Do not overload wall outlets or extension cord as this can result in a risk of fire or
electric shock. Overloaded AC outlets, extension cords, frayed power cords, damaged
or cracked wire insulation, and broken plugs are dangerous. They may result in a
shock or fire hazard.
Be sure to insert each power cord securely. To prevent hum and noise, do not bundle
the interconnect leads with the power cord or speaker leads.
CLEANING
To clean the unit, wipe its case with a dry, lint-free cloth. Do not use any cleaning
fluids containing alcohol, ammonia or abrasives. Do not spray an aerosol at or near
the unit.
BATTERY DISPOSAL
Please dispose of any discharged batteries according to local environmental/
electronic waste disposal guidelines.
LOUDSPEAKERS
Before making any connections to loudspeakers, make sure all power is turned off
and only use suitable interconnects.
SERVICING
These units are not user serviceable, never attempt to repair, disassemble or
reconstruct the unit if there seems to be a problem. A serious electric shock could
result if this precautionary measure is ignored. In the event of a problem or failure,
please contact your dealer.
EUROPE-EUROPEAN UNION NOTICE
Hereby, Audio Partnership PLC declares that this product is in compliance with
Directive 2014/53/EU, the full text of the EU declaration of conformity is available at
the following internet address:
https://www.cambridgeaudio.com/DoC
Bluetooth Radio Frequency:
2.402 GHz-2.48 GHz The Max. transmit power: 10dBm
PLUG FITTING INSTRUCTIONS (UK ONLY)
The cord supplied with this appliance is factory fitted with a UK mains plug fitted
with a 5 amp fuse inside. If it is necessary to change the fuse, it is important that
a 5 amp one is used. If the plug needs to be changed because it is not suitable for
your socket, or becomes damaged, it should be cut off and an appropriate plug fitted
following the wiring instructions below. The plug must then be disposed of safely,
as insertion into a mains socket is likely to cause an electrical hazard. Should it be
necessary to fit a 3-pin BS mains plug to the power cord the wires should be fitted as
shown in this diagram. The colours of the wires in the mains lead of this appliance
may not correspond with the coloured markings identifying the terminals in your
plug. Connect them as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter 'N' or coloured BLACK.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter 'L' or coloured RED.
The wire which is coloured GREEN/YELLOW
must be connected to the terminal which is
marked with the letter 'E' or coloured GREEN.
If a 13 amp (BS 1363) plug is used, a 5 amp fuse
must be fitted, or if any other type of plug is
used a 5 amp fuse must be fitted, either in the
plug or adaptor, or on the distribution board.
4