Power-On Utilities - Gainscha GA-2408T Series User Manual

4.2 Power-on Utilities

This printer has six power-on functions for setting or testing the printer's hardware. Press these
buttons at the same time when the power is turned on, and release the buttons with the light signal
to activate these functions.
Follow these steps to enable the boot function:
Event Description
Self-test A. Power off the printer
B. Make sure the printer is loaded with paper and close the printer cover
C. Press and hold the FEED button, and turn on the printer power. When
the ribbon Green solid alone, release the button. At this time, the printer
will print a self-test page after turning on the printer.
Enter USB A. Power off the printer
storage B. Make sure the printer is loaded with paper and close the printer cover
device C. Press and hold the FEED button and turn on the printer power. When
function the comm. Orange solid alone, release the button. At this time, the printer
will print the setting value page after turning on the printer.
Enter dump A. Power off the printer
mode B. Make sure the printer is loaded with paper and close the printer cover
C. Press and hold the FEED button, then turn on the printer. When the
online Blue and the error Red are on at the same time, release the FEED
button, and the printer is now turning on After the printer, a beep is heard,
and the printer enters the dump mode at this time, and it will print out
"NOW IN DUMP MODE"
Skip A. Power off the printer
AUTO.BAS B. Press and hold the FEED button and turn on the printer's power. When
the error Red solid alone, release the button. At this time, the printer will
hear two beeps after turning on the printer, and the printer will skip
AUTO.BAS program
Printer A. Power off the printer
initialization B. Press and hold the FEED button and turn on the printer power. When
the online Blue solid alone, release the button. At this time, the printer will
hear five beeps after turning on the printer, and the printer will print the
meter parameters are restored to the factory default settings
Ribbon The machine will automatically detect the status of the ribbon after turning
inspection on and in each thermal transfer printing mode.
34
Status Beep
lights