Ford KUGA 2020 Owner's Manual page 16

Adaptive Cruise Control
Changing the Set Speed with
Intelligent Adaptive Cruise Control
When intelligent mode is on, the system
adjusts the set speed to the speed limit
detected by the camera and the speed
limit information provided by the
navigation system.
Note: The set speed adjusts when the
system detects a different maximum speed
limit.
Note: The speed limit information provided
by the navigation map data may be
inaccurate or out of date. See Navigation
(page 426).
Note: The system alerts you if the set speed
increases beyond the speed limit. See
Adaptive Cruise Control Indicators (page
264).
If the system does not detect a speed limit,
the vehicle speed remains at the current
set speed.
You can override the set speed at any time.
You may need to override or cancel the
system in certain situations such as
inclement weather or if an incorrect speed
is set.
Note: The system may not detect and read
speed limit signs with conditional
information, for example, when a sign is
flashing, during specific time ranges, or
when children are present.
Note: Under certain conditions, the system
may not adjust the vehicle speed until after
your vehicle passes the speed limit sign.
ADJUSTING THE SET SPEED
TOLERANCE - VEHICLES WITH:
SYNC 3
You can set a permanent speed tolerance
that is above or below the detected speed
limit.
Kuga (CTD) Vehicles Built From: 28-09-2020, CG3851en enGBR, Edition date: 202008, First-Printing
(If Equipped)
Use the touchscreen to select the
following:
1. Select Settings. See Settings (page
436).
2. Select Driver assist.
3. Select Cruise control.
4. Select Tolerance.
5. Use + and - to set the tolerance.
Note: You cannot set the tolerance more
than 30 km/h (20 mph) above or below the
recognized speed.
ADJUSTING THE SET SPEED
TOLERANCE - VEHICLES WITH:
SYNC 2.5
Use the following steps in the information
display:
Menu Item
Driver assist.
Cruise control
Tolerance
Use the up and
down arrows to set
the tolerance.
268
Action
Press the menu
button.
Select Cruise
Control.
Select Tolerance.
Select the desired
tolerance.