42YG7X010.book Page 42 Thursday, September 28, 2017 6:19 PM
STORAGE
Engine Oil
1.Change the engine oil (see page 31).
2.Remove the spark plug (see page 36).
3.Pour a tablespoon (5–10 cm
cylinder.
4.Pull the starter grip several times to distribute the oil in the cylinder.
5.Reinstall the spark plug.
6.Pull the starter grip slowly until resistance is felt. This will close the
valves so moisture cannot enter the engine cylinder. Return the
starter grip gently.
STORAGE PRECAUTIONS
If your pump will be stored with gasoline in the fuel tank and
carburetor, it is important to reduce the hazard of gasoline vapor
ignition. Select a well ventilated storage area away from any appliance
that operates with a flame, such as a furnace, water heater, or clothes
dryer. Also avoid any area with a spark producing electric motor or
where power tools are operated.
If possible, avoid storage areas with high humidity, because that
promotes rust and corrosion.
Unless all fuel has been drained from the fuel tank, leave the fuel valve
lever in the OFF position to reduce the possibility of fuel leakage.
42
3
/5–10 cc) of clean engine oil into the