Operating Door Swing Handle Instructions
1. The doors on your RK1004 Enclosure are reversible. Open the door and lift it off of its hinges.
2. Remove the male and female hinge parts from the Enclosure and the door.
3. Reverse them and re-install to allow left-hand door swing.
4. Remove swing handle and reverse.
All trade names are registered trademarks of respective manufacturers listed.
RK1004 Instructions
www.belkin.com
Belkin Corporation
501 West Walnut Street
Compton, CA 90220-5221, USA
Tel: 310-898-1100; Fax: 310-898-1111
© 2005 Belkin Corporation. All rights reserved.
Page 2
Mounting Rails
Rails can be adjusted front to rear by
loosening the 1/4" - 20 hex nut and
sliding to desired location then
re-tightening the hex nut using a
7/16" wrench or socket.
P35772