Table of Contents
Advertisement
Structure
1.
Move the vertical arm to its desired position as shown in Fig. 5.
2.
Fix the rear hinge pin (1), washers (2) and screw (4) as shown in Fig. 6.
3.
Insert the pin (5) and the disc (6) into the tilt cylinder as shown in Fig. 7.
4.
Tighten the nut (7) so that the cylinder and arm can work without friction. Take care not to tighten the nut too tightly.
5.
Tighten the screw with a washer (8) as shown in Fig. 8 to secure the cover.
6.
Insert the pusher shovel (R) into the print arm. Make sure the washers
are placed on both sides and tighten the self-locking nut (see Fig. 9).
7.
Mount the print arm as shown in Fig. 5/e.
8.
Place the arm in the correct position, insert the screw and tighten the nut
loosely without tightening it.
9.
Place the pen in the hole on the arm and insert the bead breaker
suspension through the hole in the pen. Tighten the 2 screws loosely
without tightening them.
10. Attach the spring to the indicated points.
8 -
Advertisement
Table of Contents
