Table of Contents
Advertisement
5.
Place the tire bead over the mounting head so that the tire is pulled into
the rim when the tensioning table is in place.
turns.
6.
To fit the first bead of the tire, push the tire into the rim cavity and place the
bead over the mounting head so that the bead is pulled into the rim cavity
while turning.
7.
For inner tube tires, the inner tube is inserted after the first bead has been
fitted in such a way as to prevent damage during the subsequent fitting
cycle.
With successive disassemblies for the same rim and tire sizes, it is not
necessary to change the adjustment of the mounting arm and head.
After the tire is mounted, the tire can be inflated with the tire filler (Fig. 27).
The air injection system can be used to support this by pressing the foot pedal.
The air blowing out of the tensioning jaws significantly shortens the pumping
time because the resulting air cushion suddenly increases the internal tire
pressure and the heel jumps off the rim seats.
All adjustment, assembly and disassembly work must be carried out with the utmost care to prevent injury from moving
parts.
Wear safety goggles!
The air injection system can also be briefly operated to facilitate the removal of the wheel from the clamping table.
14 -
Advertisement
Table of Contents
