This machine may only be used for the purpose for which it has been designed by the manufacturer. No other use is allowed. Weber GmbH accepts no liability for damage caused by improper use or misuse. Unauthorized interventions or modifications to the machine are prohibited.
To do so, tear off the strip below and return it by letter to Brown s.a., Avenue des Artisans 14, 7822 Ghislenghien , or by fax to 068 44 88 90. PROOF OF INITIAL COMMISSIONING BY AN AUTHORIZED EXPERT FOR: Weber 1228-Monster Tyre Changer, Year of production __________, Serial No. ______________________________ Location, Date Signature expert...
Unpacking Unpack the device with a suitable tool. Carefully unpack the machine and make sure that it is in perfect condition and that no parts are damaged or missing. Included in delivery: • Tire Changer • Bucket for mounting paste •...
Structure Move the vertical arm to its desired position as shown in Fig. 5. Fix the rear hinge pin (1), washers (2) and screw (4) as shown in Fig. 6. Insert the pin (5) and the disc (6) into the tilt cylinder as shown in Fig. 7. Tighten the nut (7) so that the cylinder and arm can work without friction.
Page 9
11. Screw on the print arm as shown in Fig. 5/f. 12. Tighten the nut as shown in Fig. 5/g. 13. Screw the air tank on the back of the machine. (Fig. 10) 14. Unscrew the side plate from the machine. 15.
Page 10
Observe the specified direction of rotation when connecting the machine. If the direction of rotation of the electric motor is not correct, damage will occur within a few seconds for which the manufacturer/supplier is not liable. After complete assembly of the machine and checking the function of the individual machine parts, the tire changer must be screwed to the bottom.
Use and Maintenance Description of the machine This fully automatic tire changer is specially designed for mounting and dismounting of tires and rims with a diameter of 12 "to 28 " and a maximum wheel diameter of 1200 mm. Speed switch clamping table Clamping claws with air injection system Mounting head Mounting shaft with spring...
User manual The machine may only be operated by trained personnel who are familiar with the safety regulations. Disassembly Deflate the tire. Remove old balance weights from the rim (Fig. 20) Insert the wheel into the bead breaker in such a way that it cannot damage the rim.
Page 14
Place the tire bead over the mounting head so that the tire is pulled into the rim when the tensioning table is in place. turns. To fit the first bead of the tire, push the tire into the rim cavity and place the bead over the mounting head so that the bead is pulled into the rim cavity while turning.