Using The Ozone Generator - Waeco AirCon Service OZ1000 Operating Manual

OZ1000
6

Using the ozone generator

!
CAUTION!
 Make sure that nobody enters the vehicle or is in the vehicle
during operation.
 Air the vehicle after the purifying operation for 15 minutes.
I
NOTE
 Do not perform the purifying operation in the sunlight. At tem-
peratures of above 25 °C, the ozone quickly degenerates and
is less effective. If the temperature inside the vehicle is above
25 °C, let the vehicle cool down before performing the purify-
ing operation.
 Remove all sources of fragrance.
6.1 Purifying the vehicle interior
➤ Connect one end of the 230 V cable to the socket (fig. 1 3, page 2).
➤ Connect the other end of the 230 V cable to the 230 V mains.
✓ The 15-min-LED (fig. 2 2, page 2) lights up green.
➤ Press the START/STOP button (fig. 1 1, page 2).
✓ The 15-min-LED flashes.
➤ Press the START/STOP button (fig. 1 1, page 2).
✓ The 15-min-LED lights up.
The ozone generator produces ozone for 15 minutes.
➤ Press the ON/OFF button on the control panel (fig. 1 5, page 2) twice
until it lights up to produce ozone for 30, 45 or 60 minutes.
➤ Close all the doors and windows of the vehicle.
✓ Once the selected time has elapsed, the ozone generator stops automat-
ically.
➤ If you want to stop the purifying procedure before the time has elapsed,
press the START/STOP button (fig. 1 1, page 2) several times until the
ozone generator stops and the 15-min-LED lights up green.
EN
Using the ozone generator
15