Installing The Product On A Rack Etc - Pioneer PDK-1011 Operating Instructions Manual

Installing the Product on a Rack etc.

Be sure to observe the following precautions when moving
or installing this product with a plasma display into a rack or
other enclosure.
Precautions when moving
When moving the product more than a few meters,
first remove the speaker, then remove the plasma
display from the stand and move the speaker, plasma
Caution
display, and stand separately.
Precautions when installing in a rack
or other enclosure
When installing in a rack or other enclosure, hold the
plasma display by the handles located on the rear
and bottom of the plasma display. If you hold the
Caution
speakers, they may be damaged or twisted.
Hold the
plasma display
by its handles
and from the
bottom.
Installation precautions
Make sure that you always secure a space at least as large
as that shown in the following diagram in front of and
behind the table top stand.
Plasma display
Back
Front
Table top stand
But when using a rack for which the aforementioned
spaces cannot be secured, place the rack as close to a wall
as possible and give priority to securing the space in front.
If the stand protrudes from the rack, it could cause
unforeseen accidents such as the equipment break-
Caution ing or falling over.
When rotating, take care not to allow the display
to bump into walls or surrounding objects.
Protrusion is dangerous.
Angle of rotation
Rack
5
En