Trouble Shooting - G&G TC50K Operation Manual

8. Trouble Shooting

Problems
Display shows nothing
The message „F—2"
The message „F—3"
The message „F—5"
The message „F—L"
The message „F—H"
The message „C—L" by
Calibration
The message „C—F" by
Calibration
The message „C—H" by
Calibration
Störung der
Übertragung
Possible causes
1. The ON/OFF switch is
defect
2.Internal Circuit is defect
1.A/D-switch problem
2.Sensor is defect
Keyboard defect
1.Sensor is defect
2.A/D switch problem
1.Error by sensor
2.Error by calibration
1.Object
capacity
3.Error by sensor
Error by sensor
Unstable zero or zero not
correctly set
1.Object
capacity
2.Error by sensor
R-232 1.Parameter configuration
Error
2.Cable
problem or cable is defect
3.internal R232 Chip is
defect
Measures to take
1.the ON/OFF switch must
be changed
2.
service department
please contact our service
department
please contact our service
department
please contact our service
department
restore
configuration
weight beyond 1.remove the object
2.
configuration
restore
configuration
Press the „TARE" key with
empty pan, the balance
shows 0, then calibrieren.
weight beyond 1. remove the object, Press
the
empty pan, the balance
shows 0, then calibrieren.
2.
configuration
1.check the C3 and C4
configuration
connection 2.check the cabel
3.
service department
please contact our
the fabric
restore the fabric
the fabric
„TARE" key with
restore the fabric
please contact our
10 | P a g e