Table of Contents
Advertisement
P74056_F5D6001_man(fp).qxd
5/3/2002
5:09 PM
wireless networking
9.
Carefully screw the antenna onto the threaded connector on the Card.
Turn the antenna until it is vertical and pointing up.
10.
Replace the computer's cover.
11.
Now that the Card is installed, you can replace the cover to your
computer, reconnect all of the cables, and turn it back on. Proceed
to Step 3.
8
Page 8
wireless networking
Step 3: Finishing the Installation
1.
2.
3.
4.
5.
6.
7.
8.
Uninstalling the Software and Drivers
If you need to remove the software and drivers for any reason, you can
accomplish this easily in one of two ways. You can insert the software CD
and click on the "Uninstall" option in the menu, or you can go to the
Windows Control Panel and select the "Add/Remove Programs" option. The
Belkin Wizard will walk you through the removal process.
Turn your computer on.
Depending on your operating system, Windows OS may detect the Card
and launch the "Found New Hardware" wizard. Click "Next".
Your Windows OS may ask you where the drivers are located. Make no
changes and click "Next".
If you are using Windows 2000 or XP, you will get a message telling you
that the drivers are not "signed" by Microsoft. This does not mean there
is a problem. Click "Continue".
Your Windows OS will find the correct driver files and complete the
installation. Windows OS may tell you that the hardware is installed.
Click "Finish" if asked to.
Windows OS may ask you to restart the computer. If it does, click "Yes"
or "Restart".
When the computer restarts, an icon will appear in the bottom right-
hand corner of your screen. See below:
Windows 98, Me, 2000
Windows XP
Installation is complete. Go to the next section called "Using the Card".
9
Advertisement
Table of Contents
