Advertisement
Install the Disk
Install the Disk
The following procedure describes how to remove the drive sled and insert
the drive by connecting the IDE and power cables.
1.
Lift the drive handle and slowly pull out the drive sled. If the drive bay is
locked, use the provided key to unlock it before attempting to remove a
drive sled.
WARNING!
to the drive sled.
As the handle is lifted to 90 degrees, the drive unseats itself from the internal
connector. The drive should slide easily from the docking tray.
2.
Place the drive sled on an even surface.
Page 2
Trying to remove the drive while it is locked results in damage
Br oadc om C or por ati on
Drive
Handle
Document
BCM94780
94780-QS100-R
Advertisement
