Advertisement
Connect the Cables
Connect the Cables
The following procedure describes how to connect the network and power
cables.
WARNING!
turned off.
The connectors are on the back of the box, along with the main hard power
shutoff switch.
Network Connector
1.
Turn the BroadNAS off by pressing O on the main AC power switch
(located on the back of the BroadNAS).
2.
Connect a standard network cable to the network connector. The network
cable is similar to a phone cord.
3.
Connect the other end of the cable for:
•
A home network router device of any kind (such as a cable or DSL home
gateway or wireless router) to a network router (the broadband home
gateway, wireless router, or whatever other device controls the home
network).
•
Other (do not have a home network router device), to a home network.
This may be a network hub or the network connector of a PC if the PC is
the only other device in the home network. If there is anything more than
the BroadNAS and one PC on the network, a router, gateway, or hub is
needed for the network.
4.
Connect the supplied power cable to the AC connector and a standard wall
outlet or other power supply, such as an Uninterruptable Power Supply
(UPS).
5.
Proceed to
Page 6
Before connecting cables, always ensure that the BroadNAS is
"Turning on the BroadNAS" on page
Br oadc om C or por ati on
Main AC Power Switch
AC Connector
120V AC only
7.
Document
94780-QS100-R
BCM94780
Advertisement
