Protecting The Environment; Rechargeable Battery Pack - DeWalt DCN45RN Original Instructions Manual

EnGLIsh
nOTE: Check the return of the profile by sliding the profile
up the spring rail and letting it go. It should return due to
the force from the springs.
7. Slide the return system 18
to try the alignment of the profile and the flywheel before
screwing the return system back on to the unit. This can be
done by connecting a battery and pushing then releasing
the nose of the unit against a bench or hard surface. This will
start the motor spinning.
nOTE: When the profile and the flywheel are correctly
aligned, you will hear the motor coast back down from
full speed. If the profile and the flywheel are not correctly
aligned the motor it may not start up, may slow down much
faster than normal along with a loud grinding noise from the
unit. If this happens remove and reseat the return system.

WARNING: Always test the unit by firing short nails in
to soft wood, to ensure that the tool is working properly.
If tool does not operate properly, contact a recognized
D WALT service centre immediately.
e
Replacing the Profile (Fig. N)
To change a Broken or Worn Profile
1. Refer to Return Spring Replacement Steps 1–4 to remove
the return system from the unit and to remove the springs.
2. Take note of the orientation of the profile
profile off the rail 20
3. In the same orientation as the old profile, slide the new
profile onto the rails.
4. Refer to Return Spring Replacement Steps 5–7 to complete
the service.

Protecting the Environment

Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.

Rechargeable Battery Pack

This long life battery pack must be recharged when it fails to
produce sufficient power on jobs which were easily done before.
At the end of its technical life, discard it with due care for our
environment:
• Run the battery pack down completely, then remove it from
the tool.
• Li‑Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
42
back into the unit. It is important
24 . Slide the