Installation; Wall Mount - Cooper Lighting Streetworks Valet LED Installation Instructions Manual

Installation Instructions – Valet LED

INSTALLATION

Your lighting fixture has been shipped with one of several
types of mounting options. Please follow the installation
instructions specific to the catalog part that you ordered. If
the maintenance plan for your specific mounting application
calls for hosing down the fixture, all supply wires used must
include wet rated wire insulation and splice components.
Tools required
Flat blade screw driver, Phillips head screw driver, electrical
wiring tools.
Ceiling Mount / Quick Mount
See (Figure 1.).
1. Remove top knockout in Top Quick Mount Bracket.
2. Pull the supply wires through J-Box and through the top
knockout of the top quick mount bracket—decorative
cage.
3. Assemble top quick mount bracket—decorative cage to
J-Box [not supplied] located in ceiling using appropriate
hardware [not supplied] for the junction interface [J-Box
must be secured to ceiling structure and must be able
to support a minimum of 20 lbs.].
4. Lift fixture assembly to the top quick mount bracket
that has been attached to the ceiling/ J-Box and
connect the safety cable to the loop provided in the top
quick mount box.
5. Connect supply wires to appropriate fixture leads with
wire nuts:
a) Supply side line voltage wire to black fixture lead.
b) Supply side neutral wire to white fixture lead.
c) Supply side ground wire to green fixture lead.
6. Push the wire splices back into J-Box slide the bottom
quick mount bracket into the top quick mount bracket
and secure with two screws.
7 . The fixture is now ready to be energized.
Tools required
Phillips head screw driver, electrical wiring tools.

Wall Mount

See (Figure 2.).
1. Pull the supply wires out of J-Box [not included] and
through the large hole in the center of the attachment
plate.
2. Secure attachment plate to J-Box / wall using two
screws [not supplied].
3. Connect supply wires to appropriate fixture leads with
wire nuts:
a) Supply side line voltage wire to black fixture lead.
b) Supply side neutral wire to white fixture lead.
c) Supply side ground wire to green fixture lead.
2
Cooper Lighting Solutions
IB506019EN Installation instructions
4. Push the wire splices back into J-Box and mount the
fixture assembly to the attachment plate by tightening
the two set screws at the top and bottom of the
decorative wall mount plate.
5. The fixture is now ready to be energized.
N ote: For wet location usage, use appropriate outdoor
caulking compound [latex, silicone, etc.] to seal the
joint between decorative wall mount plate and the
mounting surface
To Junction Box (Not Supplied)
Safety Cable Loop
Safety Cable Hook
Figure 1.
Figure 2.
Decorative Cage
Top Quick Mount
Bracket
Bottom Quick
Mount Bracket
Set Screw
Attachment
Plate
To
Junction
Box (Not
Supplied)
Decorative
Wall Plate
Set Screw