Troubleshooting - Duramaxx 10027068 Manual

No picture from a
camera
The picture is
dropping
Audio problems
The picture is
or has become
choppy
The Picture
appears to be
grainy when using
AV out function
to view on a large
screen TV/Monitor
Recording
problems
Can't view via
mobile phone
24

Troubleshooting

• Check all connections to the camera. Make sure the adaptor is
plugged in.
• Make sure that the receiver is ON.
• Make sure that the camera is in range of the receiver.
• Move the camera closer to the receiver.
• Try repositioning the camera, receiver or both to improve the
reception.
• Increase the volume when there is no sound.
• Make sure that there is sound within range of the camera
microphone.
• If the unit emits a loud screeching noise (audio feedback),
move the camera or receiver farther apart.
The picture may become choppy when experiencing lower frame
rate (i.e. 10 frames per second vs. a higher 20 frames per second).
Try moving the camera closer to the receiver. Remove obstructions
between the receiver and camera.
The purpose of the AV output is for convenience only. When using
with large screen TV/Monitor, the picture might be grainy as the ca-
mera limits video resolution to VGA (640x480 pixels). This is not a
product defect.
• For best performance use with . Check your TV/Monitor product
manual to see if this feature is available on your TV/Monitor.
• View video on a smaller screen TV/Monitor.
• Make sure the SD card is inserted to SD card slot correctly
• Check the SD card is not full memory
• Make sure the size of SD card is compatible with the system.
The system can support up to 32GB SD card
• Check whether the RJ45 connector is properly connect to the
router
• Check whether you open the DHCP function in your network
• If you use state ip setting, check whether your setting is in
the same rule of your network.