Table of Contents
Advertisement
Available languages
Available languages
Senio SRL
36
| Rollator
4.
Assembly/adjustments
4.1.
Attaching the bracket for the
armrests
•
Place all parts of the rollator on the floor in front of you (Fig. 4).
•
Make sure that the handholds on the relevant sides are already
connected to the brakes via the Bowden cables.
4
•
Slide the tube with the drilled holes into the bracket so that the
holder for the forearms points down (Fig. 5).
•
Fasten the tube by inserting the screw from the inside out. Place
the curved plastic adapter (radial washer) on the outside and then
the washer on the screw.
•
Now screw the star nut onto the screw from the outside and
tighten.
•
Do exactly the same on the other side.
5
4.2.
Attaching the armrests
•
Slide the column with the armrest into the bracket so that the star
nut points outwards. Then tighten it (Fig. 6). Make sure that the
6a
ribbed surface is located within the area to be tightened (Fig. 6a).
•
Now slide the column with the handle and the brakes through the
tubes under the armrests from top to bottom (Fig. 07). Each of
6
these columns are already connected to the brakes with the side
to be used via the Bowden cable. The handles should be pointing
vertically upwards. They can also be moved to the correct position
when adjusting the armrests (see sec. 4.6, p. 14).
7
Advertisement
Chapters
Table of Contents
