Advertisement
Available languages
Available languages
MTCHEATEDM, MTCHEATEDL, MTCHEATEDXL, MTCHEATED2XL, MTCHEATED3XL HEATED SOFT SHELL JACKET KIT
• Do not dry clean . Do not use dry-cleaning fluid on this heated
jacket . Do not use bleach . Cleaning solvents may have a
deteriorating effect on the insulation of the heating element .
• Maintain labels and nameplates . These carry important
information . If unreadable or missing, contact a MATCO TOOLS
service facility for a free replacement .
Inserting/Removing the Battery
• To insert the battery, slide the pack into the body of the battery
controller . Make sure it latches securely into place .
• Insert the power cable (from inside the battery controller
pocket) into the power cable port on the battery controller .
• Place the battery controller into the pocket and zip closed . If
necessary, unzip the expansion zipper to accommodate larger
battery packs .
• To remove the battery, push in the release buttons and pull the
battery pack away from the controller .
Using the USB Port
• The USB port can be used to charge a cell phone, MP3 player,
or other personal device that uses less than USB 5V 2 .1 AMPS
of electrical current . The cord can be run from the battery
controller pocket, through the grommet and channel on the
interior of the heated jacket, and through another grommet into
a side pocket . It is not recommended to use the pocket warmer
when an electronic device is charging in a pocket .
• To turn on the USB, press the USB power button . The USB port
will remain on for two hours before turning off automatically .
Operation
• The zone power buttons are located on the upper left side of
the heated jacket . Use the heated jacket and pocket power
buttons to control the two zones . To turn "on", press and hold
(1 to 2 seconds) the zone's power button . The zone will be
turned to High and the red LED will light .
• Temperature setting can be adjusted at any time by pressing
the zone's power button . Each press will cycle through the
zone's temperature settings .
• To turn "off" the heated jacket, press and hold (1 to 2 seconds)
the zone's power button . The LED will turn off .
• If the heated jacket turns off unexpectedly, check connections
and charge the battery pack .
• If the heated jacket does not start or operate properly with a
fully charged battery pack, clean the contacts on the battery
pack . If the heated jacket still does not work properly, return
the heated jacket, charger and battery pack, to a MATCO
TOOLS service facility for repairs .
MTCHEATEDM, MTCHEATEDL, MTCHEATEDXL, MTCHEATED2XL, MTCHEATED3XL
To clean the heated jacket
1 . Remove battery pack and battery holder .
2 . Push the power cord completely into the battery holder pocket
and fasten closed .
3 . Machine wash, Gentle Cycle in warm water . Do not use bleach .
Do not dry clean . Do not wring or twist .
4 . Tumble Dry on Low Heat . Do not iron .
1 . Jacket and Pocket Power Button
High: Red LED
Medium: White LED
Low: Blue LED
2 . USB Battery Controller
VOLT
DIRECT CURRENT
MACHINE WASH, GENTLE CYCLE IN WARM WATER
DO NOT BLEACH
DO NOT WRING OR TWIST
TUMBLE DRY, LOW HEAT
DO NOT IRON
DO NOT DRY-CLEAN
3
3 . Power Cable Port
4 . USB Port
5 . Battery Controller Pocket
6 . Power Cable
08/17/18
Advertisement
