Technical Data; Installation - oventrop Regusol X-2S Installation And Operating Instructions Manual

4 Technical data

4.1 Performance data
Max. operating temperature t
Max. operating pressure p
Connections:
Fluid: Non-aggressive fluids (e.g. water and suitable
water and glycol mixtures according to VDI 2035). Not
suitable for steam, oily and aggressive fluids.
DANGER
Suitable measures (e.g. safety valves) have to be
taken to ensure that the maximum operating pres-
sures and maximum operating temperatures are
not exceeded.
4.2 Materials
Ball valve Brass, PTFE, EPDM, PA6
Check valve Brass, EPDM, PPS
Pump body Cast iron
T-piece CrNiMo steel
Pipes Stainless steel
Seals Kautasit AF400
4.3 Dimensions/connection sizes
G1
G1
G1
Illustr. 4.3 Dimensions
10
: +120 °C
s
: PN 6
s
G1 flat sealing
100
G1
G1

5 Installation

WARNING
Danger to life
Installation should only be carried out by a qualified
electrician. Before work commences, please
ensure that all components are disconnected from
the power supply.
The pipework has to be flushed thoroughly before
installation of the supplementary set.
The supplementary set is supplied pre-assembled and
leak tested.
Observe warning advice under paragraph 2
(safety notes)
CAUTION
– Do not use any lubricant or oil when installing
the supplementary set as these may destroy the
seals. If necessary, all dirt particles and lubricant
or oil residues must be removed from the pipe-
work by flushing the latter.
When choosing the operating fluid, the latest
technical development has to be considered
(e.g. VDI 2035).
– Please protect against external forces (e.g. im-
pacts, vibrations etc.).
After installation, check all installation points for
leaks.