Behringer FILTER MACHINE FM600 User Manual

Thank you for showing your confidence in us by purchasing the BEHRINGER FILTER
MACHINE FM600. This Filter Modeler delivers the whole range from funky auto-wah,
twin, band-pass to swirling low-pass filter effects—at the touch of a footswitch. Discover
the world of moving filters and take off with sounds you have never heard before.
The FILTER switch is used to select one of three filter types (BP=Band Pass,
TF=Twin Filter band pass, LP=Low Pass), which deliver completely different sounds.
Cut-off and center frequencies respond to the dynamics of your playing.
The SENS knob determines the sensitivity of the filter and hence the level at which
the filter frequency modulation starts to work.
The PEAK knob is used to define the shape of the filter from narrow to wide.
The POL switch determines whether the filter frequency moves up to higher
frequencies (UP) or down to lower frequencies (DOWN) according to the dynamics
of your playing.
With the RANGE knob, you can alter the travel range of the filter frequency.
The ON/BATT LED lights up, as soon as the effect is activated. Furthermore, you
can check the status of the battery.
The footswitch is used for switching the effect on/off.
The 1/4" TS connector (IN) connects to your instrument.
The 1/4" TS connector (OUT) sends the signal to your amp/combo.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not
included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove
the pedal cover. Be careful not to scratch the unit.
The FM600 has no On/Off switch. It is operable as soon as you insert a
plug into the IN connector. Disconnect the plug, if you don't use the
FM600. In doing so, you can extend the life time of the battery.
The SERIAL NUMBER is located at the underside.
FILTER MACHINE FM600
1. CONTROLS
Top view