Bulldog Security Titan Fitting Instructions

7.
3.
10.
9.
5.
4.
8.
6.
11.
1. CHECK LIST:- 1. Lower arms 2 off 2. Top
arm 3. Disc 4. M12 x 40 coach bolt 5. Spring
washer 6. Hollow nut 7. Cover plate 8. Lock
bolt and keys 9. Red plastic cap 10. Spanner
11. M10 x 45mm coach bolt + M10 nyloc nuts, 2
off each 12. 28mm long bushes, 2 off.
N.B. Please note items 9,8+6 are pre-assembled
into Cover plate (item 7).
11+12
1
3. Insert key and turn ¼ turn anti clockwise to
remove hollow nut from inside cover plate and
screw on finger tight but still allowing arms to
slide freely. Please ensure that the recess on back
of nut is located into hole in large spring washer.
5. With left hand lift nut and disc assembly to
centre of wheel.
Titan Wheel Clamp Fitting Instructions
2.
1.
12.
2
11+12
1
Spring washer fits
this way up.
1.
2. Position lower arms as shown and lay top arm
on top. Place in position spring washer, push
square head of M12 x 40mm coach bolt into
round disc. (Tap with hammer if tight fit) until
dome head touches disc. Offer up round disc to
lower arm, ensure that the pressed dimple on the
disc locates securely in slot in arm, this is to
prevent turning.
4. Models SW195F, 210DF, 230FD have rubber
discs included. Fit this to the rear of the steel
disc. Push extended clamp arm assembly round
base of wheel as shown.
6. Still holding nut with left hand swing round top
arm to vertical position.
3.
2.