Behringer EUROGRAND EG8080 User Manual page 23

Accept/ignore MIDI controller information
Use this function to determine how the EG8080 responds to MIDI
controller data. MIDI uses a variety of controller informaiton to
control sound changes (e.g. pedal status, volume, effect
intensity).
E7. 5
Function:
On, Off
Value:
Description:
On:
Controller data are sent and received (default setting)
Off:
Controller data are neither sent nor received
The EG8080 only responds to the commands listed
in the MIDI implementation chart if controller data
are enabled (see chapter 10.5).
MIDI transposition
This function determines whether outgoing MIDI data are
transposed independently of the built-in sound generator. This
can be useful to play the sounds of an external sound module
whose sound generator is controlled from the keyboard of the
EG8080 in a different pitch than the internal sounds of the
EG8080.
E7. 6
Function:
-12 12
Value:
Description:
0:
No transposition of the pitch at the MIDI output (default
setting)
1 12: Pitch is transposed up by the number of half-tones
selected
-1 -12:
Pitch is transposed down by the number of half-tones
selected
This setting has no effect on the sound generator
of the EG8080!
Send control panel settings (snapshot)
Use this function to transmit the current settings of the EG8080
(e.g. sounds and effects, channel volume) via the MIDI output.
This type of transmission only includes system-exclusive data
packages (MIDI dump).
E7. 7
Function:
Value: -
Description:
1) Connect the EG8080 to a computer or hardware sequencer
as described in chapter 7.3.2.
2) Set the MIDI sequencer to reception-ready mode.
3) Select the function E7. 7 in EDIT mode.
4) Press the +/YES button to execute the transmission.
When the transmission is complete, the display shows End.
Use this function to send music sequencer data via the MIDI
output of the EG8080. This allows you to archive recorded music
pieces on your music computer or hardware MIDI sequencer.
This type of transmission is only for system-exclusive data
packages (MIDI dump), but not for MIDI playing data.
Function:
Value:
Description:
1) Connect the EG8080 to a computer or hardware sequencer
2) Set the MIDI sequencer to reception-ready mode.
3) Select the function E7. 8 in EDIT mode.
4) Press the +/YES button to execute the transmission.
When the transmission is complete, the display shows End.
7. CONNECTION TO EXTERNAL EQUIPMENT
EUROGRAND EG8080-
You can send the data back to the EG8080 at a later
date. To do this, use the MIDI IN jack to connect the
EG8080 to the device that received the data before.
As soon as you start the transmission from the
MIDI sequencer, the EG8080 will automatically
receive the data. Make sure that neither DEMO,
EDIT or music sequencer mode is active!
Sending music sequencer data
E7. 8
-
as described in chapter 7.3.2.
You can send the data back to the EG8080 at a later
date. To do this, use the MIDI IN jack to connect the
EG8080 to the device that received the data before.
As soon as you start the transmission from the
MIDI sequencer, the EG8080 will automatically
receive the data. Make sure that neither DEMO,
EDIT or music sequencer mode is active!
BK
23