Midland G13 Instruction Manual page 31

TOT- Function TX timeout timer
G13 can be programmed with a transmission timer that temporarily blocks transmis-
sions if the radio has been used beyond the maximum time permitted.
The radio is forced in reception mode if it continues transmitting after the preset
timer threshold has been reached.
To restart the transmission, release the PTT key.
To enable this function:
1. Press the MENU button;
Turn the Encoder knob until TOT is displayed;
2.
Push ENT to enter the function;
3.
4. Turn the Encoder knob and set a timer from 30 to 180 seconds.
5. Confirm your selection with ENT.
6. Press BACK to exit the menu.
SCAN function
To set the SCAN mode follow these steps:
Press MENU and rotate the encoder knob until the display shows SCAN.
1.
2. Press ENT and rotate the encoder to select the type of scan mode (TO/CO/
SE). Confirm your selection with ENT.
TO - Time-operated Scan
Whenever a signal is detected, the radio will suspend the scan for 5 seconds, and
then will continue to scan even if the signal is still present.
CO: Carrier-operated Scan
Whenever a signal is detected, the radio will stop scanning. It will resume to scan
once the signal will disappear.
SE: Search Scan
The radio will stop scanning and exit the Scan mode once detected a signal.
SubAud (subaudio tones)
CTCSS tones and DCS codes are similar to access codes and enable the radio to
communicate only with the users that are tuned on the same channel and have set
the same code.
For each channel you can set up to 50 CTCSS tones, 106 DCS I codes and 106
DCS N.
To select a CTCSS tone:
1. Press the MENU button;
Turn the Encoder knob till SubAud appears on the display in TX and RX mode;
2.
3. Push ENT to enter the function;
4. Turn the Encoder knob and select the desired tone (CTC; DCS N; DCS I)
Midland G13 instruction guide | 11