Honda CRF250F 2020 Owner's Manual page 70

8. Replace the O-ring and apply a thin coat of
engine oil to the new O-ring before installing it.
9. Install the oil filter cover/O-ring and oil filter
cover bolts. Tighten the bolts to the specified
torque:
9 lbf·ft (12 N·m, 1.2 kgf·m)
10. Install a new sealing washer onto the drain bolt.
11. Tighten the oil drain bolt to the specified torque:
18 lbf·ft (24 N·m, 2.4 kgf·m)
12. Pour the recommended oil into the
crankcase;
If the oil filter was replaced:
1.5 US qt (1.4 )
If the oil filter was not replaced, use
approximately:
1.5 US qt (1.4 )
13. Install the oil fill cap/dipstick securely.
14. Start the engine and let it idle for 3-5
minutes. Stop the engine. Wait 2-3 minutes.
15.With the motorcycle held upright on level
ground, check the oil level.
If needed, add oil (page 60) until it reaches
the upper level mark. (Do not overfill.)
16.Check for oil leaks.
Engine Oil
Servicing Your Honda
63