Advertisement
PARTS IDENTIFICATION
1
2
3
4
5
1
Power switch / Light output control knob
2
Color temperature control knob
3
DC input
4
Cooling vents
5
¼ - 20 mounting socket
6
Battery indicator LEDs
7
Lithium battery mount
OPERATION
Powering the Light
Your LED80VT light may be powered in multiple ways.
AA Batteries – The light uses 6 pieces of 1.5v AA batteries. To use AA batteries, press and squeeze the battery cover
lock release on the top and bottom of the light. Open the battery compartment and insert 6 fresh 1.5v AA batteries. Use
caution not to mix battery brands or types. Be sure to insert the batteries in the direction of the diagram inside the
battery compartment. Close the battery compartment cover until it firmly locks in place. (Note: Rechargeable NiMH AA
batteries are only 1.2v. Using this battery type may result is reduced run time or cause the light to not attain the full light
output.) Note that AA batteries are not included and must be purchased separately.
Lithium Battery – The LED80VT uses a Sony "F" type lithium battery (NP-F, NP-FM, or NP-QM). To install a lithium
battery, open the battery compartment cover by squeezing the battery cover release on the top and bottom of the light.
Slide the battery onto the cover with the battery contacts matching the contacts on the cover. When the battery is fully
attached, close the battery compartment cove until it locks in place. This also locks your battery in place. To remove the
battery, open the battery compartment cover and slide the battery off of the cover. Note that the lithium battery and
charger are a separate optional purchase.
AC Power – Your LED80VT light is supplied with an AC power adapter allowing for unlimited run time. To use your light
on AC power, insert the barrel connector of the AC power supply into the DC input. Then plug the power supply into any
AC power source.
10
11
6
7
8
9
12
13
8
Battery cover
9
Battery cover lock release
10
Mounting shoe light mount
11 Mounting shoe
12
Filter mounting magnet area
13 LED panel
Advertisement
