Table of Contents
Advertisement
I N S T R U M E N T C L U S T E R
D I S P L A Y
Instrument Cluster Display
Controls
The instrument cluster display features a driver
interactive display that is located in the instru-
ment cluster. Pushing the controls on the in-
strument panel on the left side of the steering
column allows the driver to select vehicle infor-
mation and Personal Settings.
Instrument Cluster Display Controls
• Push the up arrow button to scroll upward
through the main menus (Speed Beep,
Buzzer Volume, Exit Menu) and sub menus.
• Push the down arrow button to scroll down-
ward through the main menus and sub menus.
• Push the MODE button for access to main
menus, sub menus or to select a personal
setting in the setup menu.
• Push and hold the MODE button for two
seconds to reset displayed/selected features
that can be reset.
For further information, and applicable warnings
and cautions, please refer to the Owner's Manual at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca (Cana-
dian Residents).
Instrument Cluster Dimming
With the headlights on, and without entering
into the menu, push the up or down arrow
button to increase or decrease the brightness of
the instrument panel, graphics, and command
buttons.
NOTE:
The instrument cluster display dimmer switch
can only be used to adjust the brightness when
the headlights are turned on.
Speed Beep
This function makes it possible to set the vehicle
speed limit (MPH or km/h). When this limit is
exceeded the driver is immediately alerted.
To set the desired speed limit, proceed as follows:
• Briefly press the MODE button: the display
will show the wording (Speed Beep)
• Push button or to select speed limit activa-
tion (On) or deactivation (Off)
Advertisement
Table of Contents
