Compaq ProLiant 800 Manual page 137

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
POST Error Messages
Error Code
501-Display Adapter
Failure
601-Diskette
Controller Error
605-Diskette Drive
Type Error
702-A coprocessor
has been detected
that was not reported
by CMOS.
703-CMOS reports a
coprocessor that has
not been detected
continued
Audible
Beeps
L=Long
S=Short
1L,2S Video display controller
None Diskette controller
circuitry failure
2S Mismatch in drive type
None Installed coprocessor not
configured.
2S Coprocessor or
configuration error.
Writer: Project: Diagnostics Tools Comments:
File Name: J-ch8.doc Last Saved On: 4/24/97 10:38 AM
Probable Source of
Problem
Replace the video
board.
1. Make sure the
diskette drive
cables are
attached.
2. Replace the
diskette drive
and/or cable.
3. Replace the system
board.
Run the System
Configuration Utility to
set diskette type
correctly.
Run the System
Configuration Utility
and correct.
1. Run the System
Configuration
Utility and correct.
2. Replace the
coprocessor.
Compaq ProLiant 800 Server Reference Guide
8-7
Action
continued