Charger Mounting - Duramaxx D40B2 Manual

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
2
This is a diagnostic charger. The Charger
LED Light (3) will illuminate in specific order
to communicate the current battery status.
They are as follows:
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING:
FULLY CHARGED:
BATTERY IS TOO WARM:
(REMOVE FOR APPROX. 30
MINUTES TO ALLOW TO COOL)
NO BATTERY PRESENT
DEFECTIVE BATTERY:
(REMOVE AND REPLACE WITH
NEW BATTERY IF THIS OCCURS)
False Defect Note:
When the battery is inserted into the charger,
and the status LED flashes, remove the
battery from the charger for 1 minute, then
reinsert. If the status LED indicates normal
than the battery pack is good. If the status
LED is still blinking, remove the battery pack
and unplug the charger. Wait 1 minute and
plug the charger back in and reinsert the
battery pack. If the status LED indicates
normal than the battery pack is good. If the
status LED is still blinking then the battery
pack is defective and needs to be replaced.
NOTE: When the red indictor flickers, pull out
the battery from the charger and insert again
within 2 hours. If the indictor shows charging,
that means the battery is good. After 2 hours,
please pull out the battery and also pull
out the AC power plug of the charger for 1
miniute, and then insert the AC power plug
and the battery again. If the indictor shows
charging, that means the battery is good. If
English (Original Instructions)
1
3
RED RED
RED
GREEN
ORANGE
RED
OFF
RED
RED
RED
BLINKING
not, the battery needs to be changed.
CHECKING THE CHARGER
If the battery pack does not charge properly:
▪ Check the current at the power outlet with
another tool. Make sure that the outlet is
not turned off.
▪ Check that the charger contacts have not
been shorted by debris or foreign material.
▪ If the surrounding air temperature is not
normal room temperature, move the
charger and battery pack to a location
where the temperature is between 7 ˚C and
40˚C .
If the battery is inserted into the charger
when warm or hot, the CHARGING LED
indicator light on the charger may switch
on and illuminate ORANGE. If this occurs
allow the battery to cool outside of the
charger for approximately 30 minutes.

CHARGER MOUNTING

1. This charger can be installed hanging on a
wall using two screws (not supplied)
2. Locate the placement for the charger to be
wall mounted.
3. If fastening to wood studs use 2 wood
screws.
4. Drill two holes 2 3/8" (6 cm) on center
ensuring they are level.
5. If fastening to drywall use wall anchors and
screws to secure the charger to the wall.
NOTE: If the battery and the charger won't
be used for a long time, please remove the
battery from the charger and pull out the AC
5
WARNING