Electrolux oxy3 silence Instructions Manual page 72

Electrical supply (UK and Ireland only)
Before you start ... check the voltage
Before connecting the air cleaner to an electrical supply ensure that the
voltage marked on the data plate (on the reverse side of the air cleaner) is
correct for your electrical supply. If it is not, do not use the air cleaner but
refer back to your dealer.
Connecting to your electricity supply
Permanently connected to the air cleaner is a mains supply (2-core) cable
fitted with a non-rewirable plug incorporating a 13A fuse. In the event of the
fuse requiring replacement the fuse cover should be removed using a small
screwdriver. The old fuse MUST be replaced by a 13A ASTA approved
BS1362 fuse and the fuse cover must be replaced before the plug is used
again. In the event of loss of the fuse cover, replacements can be obtained
from your Electrolux dealer or Electricity Board and must be of the same
colour as indicated by the coloured insert on the base of the plug.
If difficulty is experienced in obtaining a replacement, contact your nearest
Electrolux Service Centre. (Please see the separate Electrolux Service
Organisation leaflet).
In no circumstances must the plug be used without a correct fuse
cover fitted.
If the plug that is fitted to your appliance is not suitable for your socket
outlet, it must be cut off and the appropriate plug fitted. Remove the fuse
from the cut off plug. The cut off plug should then be disposed of to prevent
the hazard of shocks in case it should be plugged into a 13 amp socket in
another part of your home.
The wires in the mains cable of this appliance are coloured in
accordance with the following code:
Blue: Neutral.
Brown: Live.
As the colours of the wires in the mains cable of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is
marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which
is marked with the letter L or coloured red.
If using a three-pin plug, do not make any connection to the terminal
marked with the letter E or by the earth symbol
green-and-yellow. This cleaner is double insulated and no earth connection
is necessary.
It is in your interest to ensure that the plug is correctly attached to the
mains cable. In case of doubt, have it done by a qualified electrician, as
Electrolux cannot regard the repair of faults on the plug connection as a
service that can be given free of charge under the terms of the guarantee.
As a general guide to fitting any plug:
• Ensure the lengths of wire inside the plug are prepared correctly.
• Connections should be firmly made after all conductor strands are
entered into the terminal posts.
• When preparing the cable ends take care not to damage the outer
sheath, or the insulation surrounding the inner conductors.
• Tighten all screws.
• Replace the top cover of the plug and secure.
ANY PROBLEMS?
Don't understand the instructions?
DON'T TAKE
IT BACK TO THE SHOP
We are only a telephone call away.
64
or coloured green or
Something missing?
Need more help?
CUSTOMER HELPLINE
08706 055 055