Advertisement
SKI set instructions
The SKI set with xRover Ski skis is intended as an accessory for xRover carts,
but it can be easily used on a wheelchair or sports pram with a wheel size of
up to 20 inches.
The ski set can be delivered in the number of 2/3/4 skis with a safety strap on
the hand and carry-on bag.
Maintenance of the SKI set is simple. It is performed under running water
using common non-abrasive cleaning agents. Never use thinner, benzine,
toluene or other chemicals for cleaning. Wheel oil or equivalent can be used
to lubricate the binding axles.
ATTENTION! Do not expose to temperatures above 90 degrees Celsius. Do
not dry on radiators, direct heaters, stoves.
The attachment of the skis to the cart / pram is performed by means of
adjustable spacer axles, which slide in the cut-outs of the rail, which is
attached to the ski.
The location of the axles in Fig. 1 is for 20 inch wheels, Fig. 2 and Fig. 3 show
how the axles can be moved for mounting on smaller wheels.
Advertisement
Table of Contents
Related Manuals for Apex Digital SKI set
Summary of Contents for Apex Digital SKI set
- Page 1 20 inches. The ski set can be delivered in the number of 2/3/4 skis with a safety strap on the hand and carry-on bag.
- Page 2 The spindle is equipped on one side with a drum winch and on the other side with a nut for securing it. To fasten the wheel, it is necessary to loosen up this nut on both axles and move both axles so that the wheel of the cart is placed on the bottom of the rail and secured on both sides by axles against movement.
- Page 3 Extend the required length of cable to allow you to pass the cable through the wheel to the other side. Perform the same operation on the second drum reel. Pass the cable through the wheel so that it does not collide with the valve, the wires of the wheel string or its spokes if you have plastic wheels.
- Page 4 On the other side of the wheel, hold the cable eye by the axle nut. Make sure that the eye is completely attached under the nut flange. After properly securing the cable to the nut, grasp the cable tensioner on the drum winch with two fingers and pull it to unlock it.
- Page 5 The width of the rail allows the rear wheels of the xRover to be placed obliquely, while maintaining the horizontal position of the ski relative to the ground. The front 14-inch wheel settles vertically without tilting. In the same way, the skis can be fastened to an ordinary pram without inclined wheels. ATTENTION! After putting on the skis, always use a safety strap, which you attach at one end to the handle of the cart and put the other around your wrist.
Need help?
Do you have a question about the SKI set and is the answer not in the manual?
Questions and answers