Seecode QI Manual page 9

this point. A vacuum is created in the holder when it is attached.
This can only take place when the gel pad is fully supported
everywhere. Clean it and make sure that it is clean and free of
grease. Now remove the suction base and the mobile phone
holder from the packaging. Loosen the screw nut on the back
of the mobile phone holder and remove it. Slide the screw nut
with the narrow side first over the ball on the suction foot holder.
Now place the ball of the suction foot holder in the opening
on the back of the mobile phone holder and press it in. As this
connection is quite tight, a little more pressure must be applied.
The suction foot holder locks in place loudly. Now secure this
connection with the screw nut.
The mobile phone holder and suction cup are now connected.
At the back of the suction foot you will see a lever which you
can push up and down. If the lever is up, the suction foot is
open, if it is down, the suction foot is activated.
To fix the holder on the dashboard, the suction foot must be in
the open position. To do this, point the lever upwards.
Now press the holder firmly
onto the desired position and
press the lever further down
until it locks into place. The
resulting vacuum holds the
holder firmly on the surface.
To release the holder, simply
put the lever upright again