Huawei SUN2000-8KTL Quick Manual page 14

Replacing guide

Hide thumbs Also See for SUN2000-8KTL:

SUN2000-(8KTL–20KTL)-M0 Replacement Scenario

Remove SUN2000-

Start

(8KTL–20KTL)-M0.

1.1

Removing SUN2000-(8KTL–20KTL)-M0

•

Before removing the original SUN2000, ensure that the DC switch on the SUN2000 and all

the switches connected to the SUN2000 are set to OFF. Otherwise, the high voltage of the

SUN2000 may result in electric shocks.

•

After the SUN2000 is powered off, the remaining electricity and heat may still cause electric

shocks and body burns. Therefore, put on protective gloves and begin operating the SUN2000

five minutes after the power-off.

Removing Cables from SUN2000-(8KTL–20KTL)-M0 for Future Use

1. Power off the SUN2000 to be replaced.

2. Remove the AC connector for future use.

3. Remove the DC connectors and use a cable cutter to cut off the terminals of DC input power

cables. Set the cables aside for future use.

DC input terminals

Install SUN2000-

(8KTL–20KTL)-M2.

Perform the SUN2000-(8KTL–

End

20KTL)-M2 deployment wizard.

Perform SUN2000-(8KTL–

20KTL)-M2 electrical connections.

Check the installation and

power on the SUN2000.

AC output port (AC)

Cable

cutter