Bosch CR 10 H Manual page 26

Information for heating contractor
Setting Adjustment
range
L.1 1 | 0
C.1 C | F
S.1 nF.12.01
F.1 1 | 0
U.2 0 ... 999
U.3 3 ... 6 ... 12
U.4 1 | 0
U.5 1 | 2 | 3
U.6 30 ... 60 ... 120
U.7 10 ... 15 ... 60
1) Highlighted values = Default setting
2) Only one CR 10 H must be allocated to each heating circuit.
3) Turn the selector to read out the whole value.
4) Certified by the German Institute for Building Technology (DIBT)
A reset restores the default setting. In the event of a power failure, the settings
including the heating circuit allocation are retained.
26
Description
1)
Optimised running of the pump: in the case of
flow temperature control, the heating pump
runs as briefly as possible. Switch off, if there
is a buffer cylinder in the system.
Unit of displayed temperature °C (C) or °F (F)
Software version
Resetting CR 10 H
0: Do not reset
1: Reset
Nominal flow rate m
Filter runtime in months
Bypass installed
1: Yes
0: No
Frost protection
1: Interval
2: Disbalance
3: Electric pre-heater bank
Sleep mode duration in minutes
Intensive ventilation duration in minutes
3)
3
/h
4)
4)
CR 10 H – 6720876740 (2017/08)