Trouble Shooting - ZIPPER MASCHINEN ZI-KS210 User Manual

16

TROUBLE SHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Engine doesn't run
(or not correctly)
Saw blade gets stucked
Material kickback
Wrong cutting angle
Wrong mitre angle
Saw blade touches the
machine bed
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY CONNECTION TO
THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you have not
the prescribed training for it always attract a workshop to fix the problem.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-KS210
Possible cause
 Switch defective
 Power supply is off
 Carbon brushes defective
 Motor defective
 Blunt saw blade
 Too hard materal or too
much pressure
 Blunt saw blade
 Wrong running direction
of the saw blade
 Wrong adjusted fence or
saw aggregate
 Adjusting the cutting
depth wrong
N O T I C E
TROUBLE SHOOTING
Solution
 Repair switch
 Repair power supply
 Chang carbon brushes
 Repair or change motor
 Sharpening or changing
 Conform the cutting
speed on work piece
hardness and engine
power
 Sharpening or changing
 Control
 Control
 Control
33