NOTE:
•
The rear-facing recline angle of the child restraint should be 30º-45º
from vertical (not to exceed 45º from vertical) when car is parked
on a level surface.
•
The rear-facing recline angle can be adjusted by placing a rolled
towel or pool noodle in the crease of the vehicle seat, and restraint
can be stabilized by tightening tether as shown in figure C, using
anchor point 3.
•
It may be necessary to loosen tether and vehicle seat belt before
adjusting recline position.
Rear-Facing Tether Connector Strap
WARNING!
strap for rear-facing tether installation.
Because every vehicle model is different, sometimes
you cannot find a location to properly anchor the
tether, or the structural part of seat is too large
for the hook. Use rear-facing tether connector strap (fig. D) to assist in
creating an anchor point.
1
Find a fixed vehicle seat belt anchor or vehicle seat leg (that is bolted
to the floor) to which the strap can be wrapped around.
2
If you cannot find an acceptable location to create an anchor point,
contact vehicle manufacturer to identify a suitable tether connection
point.
3
Loop strap around metal anchor.
4
Take metal D-ring and thread it through webbing loop on other end
of strap.
5
Pull metal D-ring all the way through until strap is tight around metal
anchor.
6
Use D-ring as an attachment point for hook on tether strap.
Installation: Versa-Tether
Only use tether connector
D
®
25